签到有奖
消息提醒
运维工程师专区
官方商城
扫码分享好友 任选多种周边
程序中 none 是什么意思?谁知道?
著作权归作者所有。商业转载请联系作者获得授权,非商业转载请注明出处。
帖子链接:https://www.ad.siemens.com.cn/club/bbs/post.aspx?a_id=1511529&b_id=46&s_id=0&num=4
当然是变量名
话说这程序看上去很凌乱啊
系统的枚举类型,这里指的是轴对发生错误的反应,见下面详细说明:
EnumAxisErrorReaction
NONE (93) No response
DECODE_STOP (184) Cancel the command preparation
END_OF_MOTION_STOP (185) Cancel when the command that caused the error completes
MOTION_STOP (186) Motion stop with programmed values
MOTION_EMERGENCY_STOP (187) Motion stop with maximum limit values
MOTION_EMERGENCY_ABORT (188) Motion stop with maximum limit values and cancel of the active commands.
FEEDBACK_EMERGENCY_STOP (189) Motion stop on the fast stop ramp and cancel all commands
OPEN_POSITION_CONTROL (190) Motion stop with speed setpoint 0 and cancel all commands
RELEASE_DISABLE (191) Motion stop with controller lock and cancel all commands
分享
扫码分享好友 任选多种好礼
收藏
有帮助
欢迎您访问支持中心!
丰富的视频,全方位的文档,大量的网友交流精华……
为了更好的完善这些内容,我们诚邀您在浏览结束后,花20秒左右的时间,完成一个用户在线调查!
感谢您的支持!
密码至少8位,包含大、小写字母,数字和符号至少三种。
允许邮箱和手机接收来自支持中心网站的信息
我已同意《支持中心网站注册协议和隐私政策》
微信登录扫码一键登录
验证码登录
密码登录
二维码失效点击重试
打开微信扫一扫,快速登录/注册
未注册手机验证后自动登录,注册即代表同意《支持中心网站注册协议和隐私政策》
三日内免验证登录
短信登录
登录